pic: Ringer Supported by Both Spider and Stinger

Lil' Lavery · #1 16-01-2007, 17:24

Where are you guys hiding this (partial) rack? I was there this morning, and I didn't see this.

Nate Laverdure · #2 16-01-2007, 18:49

Quote:

Originally Posted by Lil' Lavery

Where are you guys hiding this (partial) rack? I was there this morning, and I didn't see this.

This is 122's rack, not 612's. I'm at ODU in Norfolk, and I'm helping out 122 (NASA Knights) in Hampton.

Ty Tremblay · #3 17-01-2007, 08:37

does anyone know the dimentions of the stinger? we tried to find it but failed.

Nate Laverdure · #4 17-01-2007, 15:45

Quote:

Originally Posted by icdumbpeeps305

does anyone know the dimentions of the stinger? we tried to find it but failed.

The stinger sticks out 4" from the top of the end plate. Look at the rack sub-assembly documentation (http://www2.usfirst.org/2007comp/Dra...emblies_R-.pdf) for more info.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: Full Scale Prototype Ringer Arm 2007	lynca	Extra Discussion	5	20-01-2007 00:25
pic: Test Rack Stinger Detail	MrForbes	Extra Discussion	14	09-01-2007 22:39
pic: 2 ringer spacing	Ryan Foley	Extra Discussion	3	07-01-2007 01:31
pic: Spoiler and Ringer on top leg 2	Ryan Foley	Extra Discussion	1	07-01-2007 01:25