|
|
|
 As engineers we should aspire to create, not destroy. If this is the case, why would we want to create machines with the sole purpose to destroy?
- WakeZero [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| As engineers we should aspire to create, not destroy. If this is the case, why would we want to create machines with the sole purpose to destroy?
- WakeZero [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Banebot 2 motor adapter
ok, my caliper is on (inches)....
2.5 on the dot for height, 5.73 width, 1.7 depth. On the bottom is a pill shaped plate that is a tad bit thicker than 1/8 inch; .153". This plate does not extrude pass the main body of the casing. If you want any more messages, just ask. (soon rather than later because once we mount these things, it may be a little bit of a problem getting the measurements. |
|
#2
17-01-2007, 16:06
|
||||
|
||||
|
Re: Banebot 2 motor adapter
Awesome!
I designed for a 6" o/a width, so it looks like I game myself some breathing room. I know some folks were looking for these dimensions on another thread, I'll be sure to link them to your post. Thanks, BEN |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BaneBot Transmission Encoder | Daru | Motors | 9 | 27-01-2007 23:17 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
| CIM motor shaft extender (adapter) | Arkorobotics | Motors | 9 | 08-02-2006 06:53 |
Hybrid Mode
