|
|
|
 However I did tell my wife I wanted to lose 20lbs of ugly fat quickly. She told me to cut off my head. Go figure. - Ed Coleman [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| However I did tell my wife I wanted to lose 20lbs of ugly fat quickly. She told me to cut off my head. Go figure. - Ed Coleman [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#5
17-01-2007, 16:02
|
||||
|
||||
|
Re: Banebot 2 motor adapter
ok, my caliper is on (inches)....
2.5 on the dot for height, 5.73 width, 1.7 depth. On the bottom is a pill shaped plate that is a tad bit thicker than 1/8 inch; .153". This plate does not extrude pass the main body of the casing. If you want any more messages, just ask. (soon rather than later because once we mount these things, it may be a little bit of a problem getting the measurements. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| BaneBot Transmission Encoder | Daru | Motors | 9 | 27-01-2007 23:17 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
| CIM motor shaft extender (adapter) | Arkorobotics | Motors | 9 | 08-02-2006 06:53 |
Threaded Mode