|
Re: pic: FRC488 Chassis Coming Together
It looks good M.
How much bearing support do you have on each wheel? Is it a completely cantilevered system? I assume you are going to include bumpers into this system. Are you going to add cross bracing when you add your end effector for additional support. Also did you run any numbers on loads on the sides of the bot. If so what did you use for an impact load? Thanks!
__________________
MORT (Team 11) '01-'05 :
-2005 New Jersey Regional Chairman's Award Winners
-2013 MORT Hall of Fame Inductee
NUTRONs (Team 125) '05-???
2007 Boston Regional Winners
2008 & 2009 Boston Regional Driving Tomorrow's Technology Award
2010 Boston Regional Creativity Award
2011 Bayou Regional Finalists, Innovation in Control Award, Boston Regional Finalists, Industrial Design Award
2012 New York City Regional Winners, Boston Regional Finalists, IRI Mentor of the Year
2013 Orlando Regional Finalists, Industrial Design Award, Boston Regional Winners, Pine Tree Regional Finalists
2014 Rhode Island District Winners, Excellence in Engineering Award, Northeastern University District Winners, Industrial Design Award, Pine Tree District Chairman's Award, Pine Tree District Winners
2015 South Florida Regional Chairman's Award, NU District Winners, NEDCMP Industrial Design Award, Hopper Division Finalists, Hopper/Newton Gracious Professionalism Award
|
There's no finer engineering than pit engineering. - kaszeta [more] 
17-01-2007, 17:17
Similar Threads
Threaded Mode