|
|
|
 Q&A is certainly a good route to take, but depending on how gray the topic in question is, CD is certainly a good place to ask the question. - slijin [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Q&A is certainly a good route to take, but depending on how gray the topic in question is, CD is certainly a good place to ask the question. - slijin [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||||
|
|||||
|
Chains on inventor 11
has anyone tried to use the chain tool over the design accelerator session (the 6th tool, the last "subtool")?
I can't make the chain itself, everytime I try only the sprockets with a line where the chain should be appear...has anyone made the chain itself through there? thanks |
|
#2
17-01-2007, 19:43
|
||||
|
||||
|
Re: Chains on inventor 11
I don't think the chain tool actually makes chain. Our team tried it on Inventor 10. Just a small hint: chain can be made out of a simple belt with a sketch embossed and cut out on it
 . |
|
#3
17-01-2007, 20:48
|
|||||
|
|||||
|
Re: Chains on inventor 11
Quote:
 |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| #25 & #35 chains | JohnMorenski | Technical Discussion | 16 | 11-01-2007 19:24 |
| VEX Chains | chewy | VEX | 13 | 21-11-2006 14:14 |
| chains | sburro | Technical Discussion | 13 | 07-10-2004 11:37 |
| chains in 3ds | tinsLee123 | 3D Animation and Competition | 4 | 17-02-2003 00:14 |
| chains | enjoiwheels | Inventor | 0 | 08-02-2003 19:33 |
Linear Mode
