Bearings and axel size - Chief Delphi

17-01-2007, 20:47

Adama

Registered User

AKA: Matthew Eastman

FRC #2199 (Robo-Lions)

Team Role: Mentor

Join Date: Jan 2006

Rookie Year: 2005

Location: Eldersburg, MD

Posts: 134

Bearings and axel size

Today i pressed the bearings into the KOP wheels and then went to grab the axel to see them spin. I found out that neither the thin axel or thick axel is the correct size. the thick being to large and the skinny not wide enough. Am i missing something or is there a mistake in the KOP?

« Previous Thread | Portal | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Forum Jump

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Axel Diameters	Booger	Technical Discussion	18	25-07-2006 19:20
Robot size and weight	Covey41	Rules/Strategy	8	10-01-2005 10:32
A little tip about those drill transmissions and bearings	archiver	2001	6	24-06-2002 00:22
weight and size of parts	Greg Needel	Kit & Additional Hardware	2	27-01-2002 23:25
Are bolts to hold wheels on, and bearings, considered "fasteners"?	kmcclary	Off-Season Events	3	22-10-2001 23:35

All times are GMT -5. The time now is 23:30.

The Chief Delphi Forums are sponsored by Innovation First International, Inc.