|
|
|
 Based on my experience coaching basketball and robotics, there is no doubt in my mind that if a sports coach receives $x then a robotics coach should, too. - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
18-01-2007, 00:03
|
|||||
|
|||||
|
Re: Mounting the PIAB Suction Cup
I have a lathe, I don't see what the problem is. Cut some threads in a piece of metal to fit the part. I guess if you don't have a lathe, then you see the problem differently than I do.
If the 3/8 NPT tap happens to have the same thread pitch, and the conical tap happens to have the same diameter as the suction cup at some point along it's length, you might consider making a thin nut from 1/4" aluminum stock. The threads will not be a perfect fit, but they could be close enough. Last edited by MrForbes : 18-01-2007 at 00:11. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: how not to use a suction cup | Sterno | Chit-Chat | 28 | 11-02-2007 17:00 |
| Suction Cup Nut | IfIwasarichman | Technical Discussion | 5 | 31-01-2007 08:21 |
| Suction Cup CAD/Schematic?? | brennerator | Inventor | 3 | 14-01-2007 23:00 |
| More clarification on the suction rules | Natsume | Rules/Strategy | 7 | 15-01-2003 01:04 |
| Who do you think will the Stanley Cup in the NHL?? | Matt Attallah | Chit-Chat | 24 | 11-04-2002 10:01 |
Threaded Mode