strongest 80/20 fastener

[GMKlenklen]

Ok, sweet.
The reason I didn't specify the application was because net cut is at 12am... it was 12am.

Generally, most connections would be between two or more 10 series tslot excrusions(sp?) at 90* to eachother. Also there would be several bearing block attachments and the ocasional securement of 3/8" plywood or lexan.
no welding.

Thank you all for responding to my very general and poorly constructed question!

GMKlenklen,

In the case of 90 degree corners, I think artdutra04's answer is the best given the stock connectors. The triangular uppler/lower corner brackets (with 3 bolt holes on each leg) is the most secure option for bolting the two pieces together. Assuming the main forces will be pushing the two toward each other (i.e. if this is for your robot frame), then the second best option is using the inside corner bracket. If you need to put something close to the inside of this angle, then the outside corner bracket and an angle bracket may be the way to go.
Pillow blocks can either be bolted to a biscut in the frame, or if you're willing to give up the adjustability of the pillow blocks, they can be bolted through the frame.
In my expereiences with my former team, I think we may have used all of the methods above at some point or another, and our robot never fell apart (although we normally find a bolt or two lying at the bottom of the shipping crate each time we move it...)
My apologies if I seemed a little curt; I had just finished my statics homework, so I was still in that nit-picking state of mind. Best of luck this season,

Mike

[DonRotolo]

Extrusion connectors don't handle impact or shock well - although the gusset plates for corners are probably stronger than you need, and two of the barrel connectors (the ones they mill into the end) are probably good enough.

We used single barrel connactors on our chassis last year, and they were always coming loose. Gusset plates and the cheap T nuts fixed that.

Don

[=Martin=Taylor=]

Well I don't know if they will suit your application, but toilet bolts are by far my favorite 80/20 fastener.

They are a conventional size (1/4-20) and are very strong. I like them because they are longer then most 80/20 fasteners and are bolts rather then nuts (biscuits).



They can also be bought at any hardware store.

(Oh, and Happy Birthday )