|
|
|
 Because, y'know, FIRST can't make it easy for us. - WinterPoet [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Because, y'know, FIRST can't make it easy for us. - WinterPoet [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#2
19-01-2007, 18:21
|
||||
|
||||
|
Re: Programming Pneumatics?
Check the following threads for some basic information:
http://www.chiefdelphi.com/forums/sh...ad.php?t=44079 http://www.chiefdelphi.com/forums/sh...ad.php?t=34872 Pneumatics are fairly simple to program and are run off of spikes. There have been quite a few posts similar to this one so in the future please search before you post, especially with such a general question. |
|
#3
20-01-2007, 00:30
|
|||
|
|||
|
Re: Programming Pneumatics?
Basically, the two main components, compressor and valves, are run off of spikes. The compressor only really needs to go in one direction, pumping into the tanks. The valves need two, one for pushing, one for pulling. Use spikes for both, and note that you only need to send a single pulse at a time to the valves, but you treat the compressor like a motor. Check out the IFI Robotics page on Spikes and the Programming manual to figure the programming.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| programming motors with programming kit | BorisTheBlade | FIRST Tech Challenge | 4 | 01-11-2005 19:03 |
| Programming of Pneumatics | Ben Piecuch | Programming | 3 | 18-02-2005 02:39 |
| Pneumatics Programming | KWalsh | Programming | 8 | 19-02-2004 09:17 |
| Programming PBASIC for pneumatics | archiver | 2001 | 2 | 23-06-2002 23:58 |
| Pneumatics electrical wiring and programming | archiver | 2001 | 1 | 23-06-2002 23:10 |
Linear Mode
