|
|
|
 Two robots run in to a bar, the third one had a better driver - Wayne Doenges [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Two robots run in to a bar, the third one had a better driver - Wayne Doenges [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
|
Servo Control?
I am trying to operate a servo with the first controller. For some reason I can not get the servo to operate by plugging it into the pwm output even though my speed controller works fine when plugged into that output. I am using the 2004 controller. Any suggestions?
|
|
#2
20-01-2007, 13:04
|
||||
|
||||
|
Re: Servo Control?
Quote:
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Direct control of a Servo or Speed Controller | Schmitty! | National Instruments LabVIEW and Data Acquisition | 3 | 06-03-2006 13:53 |
| Servo Help | Chase | Programming | 1 | 06-02-2006 17:53 |
| Servo behavior question / advanced servo/PIC programming question | DanL | Electrical | 12 | 18-10-2005 18:33 |
| Servo Rotation | indieFan | Motors | 6 | 13-11-2004 13:41 |
| Servo | MASherry | General Forum | 6 | 04-10-2004 22:46 |
Linear Mode
