Servo Control?

mattg101 · #1 20-01-2007, 13:01

I am trying to operate a servo with the first controller. For some reason I can not get the servo to operate by plugging it into the pwm output even though my speed controller works fine when plugged into that output. I am using the 2004 controller. Any suggestions?

Dave Flowerday · #2 20-01-2007, 13:04

Quote:

Originally Posted by mattg101

I am trying to operate a servo with the first controller. For some reason I can not get the servo to operate by plugging it into the pwm output even though my speed controller works fine when plugged into that output. I am using the 2004 controller. Any suggestions?

Do you have the backup battery connected? It is required to power the servos.

mattg101 · #3 20-01-2007, 13:12

Thanks that worked.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Direct control of a Servo or Speed Controller	Schmitty!	National Instruments LabVIEW and Data Acquisition	3	06-03-2006 13:53
Servo Help	Chase	Programming	1	06-02-2006 17:53
Servo behavior question / advanced servo/PIC programming question	DanL	Electrical	12	18-10-2005 18:33
Servo Rotation	indieFan	Motors	6	13-11-2004 13:41
Servo	MASherry	General Forum	6	04-10-2004 22:46