pan/tilt connection for 2007 camera

kasemodz · #1 13-01-2007, 15:18

Sry keep changing it, but basically the camera on the workbook is 2006 and the 2007 we are having problems connecting our servo motors. How do we connect the servo motor into the camera?

iBheat · #2 13-01-2007, 17:53

You don't you connect the servos to the RC. If you are using Kevin's code then its PWM01 and PWM02! The servo headers were removed from the Camera board!

Kingofl337 · #3 16-01-2007, 13:59

Quote:

Originally Posted by iBheat

You don't you connect the servos to the RC.

I think you meant: You don't you connect the servos to the camera.

MattD · #4 16-01-2007, 14:15

Quote:

Originally Posted by iBheat

You don't you connect the servos to the RC. If you are using Kevin's code then its PWM01 and PWM02! The servo headers were removed from the Camera board!

Quote:

Originally Posted by Kingofl337

I think you meant: You don't you connect the servos to the camera.

iBheat was correct. The servos must be connected to the RC (unless last year's camera is used, though I'm not sure if that is allowed or not).

Ken Streeter · #5 17-01-2007, 16:49

Quote:

Originally Posted by MattD

...unless last year's camera is used, though I'm not sure if that is allowed or not).

Just FYI, the CMUcam cameras in the 2006 Kit-of-Parts can not be used on a 2007 FRC robot. For more information, see the official Q&A.

iBheat · #6 21-01-2007, 14:21

Quote:

Originally Posted by Kingofl337

I think you meant: You don't you connect the servos to the camera.

Oops, you are right! I guess I was tired

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Linear Mode Switch to Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Why use the RC to control Pan/Tilt	Joe Hershberger	Programming	15	30-01-2007 23:41
Question about pan/tilt	itsme	Programming	1	12-01-2007 10:49
pan & tilt errors	itzrobz	Programming	2	19-02-2006 19:12
CMUCam pan and tilt	sheyna	Programming	9	14-01-2006 23:20
White Paper Discuss: Assembly of the 2006 pan/tilt camera mount	Justin Stiltner	Extra Discussion	2	09-01-2006 11:17