Problem with easy c pro and mechanum wheels

[pbrules15]

That is correct. Although, today I have found my problem, and now it works perfect. Well, almost. All the wheels do not move at exactly the same speed and the robot drifts a little bit, but I think the problem could be our joysticks.

But I do have another question. I have heard that in Easy C Pro you can type in the code manually instead of using the flow chart. But I cannot figure out how! I checked the help file. It says that you can, but I cannot figure out how. How?

[Madison]

Originally Posted by pbrules15

That is correct. Although, today I have found my problem, and now it works perfect. Well, almost. All the wheels do not move at exactly the same speed and the robot drifts a little bit, but I think the problem could be our joysticks.

But I do have another question. I have heard that in Easy C Pro you can type in the code manually instead of using the flow chart. But I cannot figure out how! I checked the help file. It says that you can, but I cannot figure out how. How?

Does your mecanum drive have any feedback installed or is it completely open loop? If it's open loop, the problem is probably not with your joysticks -- but with the inherent inequalities in the mechanical properties of the motors and gearboxes controlling each wheel.

[Kingofl337]

You click on the Project Tab and Add a source file by right clicking on "Source Files". You can also right click on a function you have created and right click and convert it to "C" code.

Also, we had some trouble with the encoders coming loose at the end of the season and it caused issues
with the robot drifting while driving strait. So we went open loop and it was better then malfunctioning encoders
but not a whole lot.

[pbrules15]

Thanks for the help!

So, for example, we cannot edit the operator or atonomous function because we did not create it ourselves?

Also, we are havin a big ole problem. We cannot figure how to make the camera track in easy c pro. I cannot find an example of the camera tracking in easy c pro. HELP!

[Dad1279]

Originally Posted by pbrules15

Thanks for the help!

So, for example, we cannot edit the operator or atonomous function because we did not create it ourselves?

Also, we are havin a big ole problem. We cannot figure how to make the camera track in easy c pro. I cannot find an example of the camera tracking in easy c pro. HELP!

Our program team found this a helpful start: http://www.intelitekdownloads.com/easyCPRO/

[pbrules15]

Is there any example of someones code for the camera written in easy c pro?

[artdutra04]

Originally Posted by pbrules15

Is there any example of someones code for the camera written in easy c pro?

Download the "2007 Kickoff Demo Code" on the Intelitek Downloads page - this code tracks the target lights.
http://www.intelitekdownloads.com/easyCPRO/

[Kingofl337]

There is also some demo graphics display camera code is Test Code / Graphics Display.