|
|
|
 An inability to communicate your ideas effectively is a handicap you would be well served to strive to overcome. - Ether [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| An inability to communicate your ideas effectively is a handicap you would be well served to strive to overcome. - Ether [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
22-01-2007, 23:08
|
||||
|
||||
|
Re: Cmucam overheating
OK, I'll try messing the the PWMs and I'll see if I can get some outputs for you. I'm not able to check now but I'll get back tomorrow.
I'm sorry to say but I am a bad programmer and know nothing about this camera, and I'm the only programmer. So I'll try and give as much info as I can but I may not be able to say it in any coherent manner. And if anyone has a for dummies type of cmucam document it would be greatly appreciated. Thanks Josh |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| CMUcam-II | Branden Gee | Programming | 9 | 18-12-2006 17:41 |
| CMUCam on Vex | gabrielse | Programming | 1 | 24-04-2006 10:11 |
| cmucam lighting | muy dificil | Programming | 5 | 22-12-2005 07:49 |
| CMUcam 2 problems | KChampion | Programming | 1 | 07-06-2005 10:39 |
| Drill Motors....OVERHEATING, DRIVETRAINS! | Brian48216 | Motors | 19 | 19-03-2003 10:18 |
Threaded Mode