pic: 968 - More unfinished parts!

Kirk · #1 23-01-2007, 13:37

Its not tables and its not ABS but it is a type of plastic and it is going on the robot.

AdamHeard · #2 23-01-2007, 13:43

Quote:

Originally Posted by Kirk

Its not tables and its not ABS but it is a type of plastic and it is going on the robot.

Black HDPE? PVC?

Kirk · #3 23-01-2007, 14:06

Getting close. Has better strength properties then those.

lukevanoort · #4 23-01-2007, 14:13

Garolite?

Cody Carey · #5 23-01-2007, 18:11

Polycarbonate?

Andrew Blair · #6 23-01-2007, 18:15

It does look most like a clear polycarb on a black background.

Rickertsen2 · #7 23-01-2007, 20:31

I really hope those are CNCed. Those would take forever to fabricated manually.

Cory · #8 23-01-2007, 20:35

Quote:

Originally Posted by Rickertsen2

I really hope those are CNCed. Those would take forever to fabricated manually.

They are definitely CNC'ed. We were very glad about that, since it meant we wouldnt have to be slaving over our lathe for weeks to make them all

GUI · #9 23-01-2007, 22:54

My guess is that 968 has uncovered the secret to a complete pwnage drive, and it involes many shafts spinning at high speeds to make all of their tubes go on the rack and all three bots on their alliance to levitate.

Holtzman · #10 23-01-2007, 23:01

Gearbox Shafts

1st stage

3 Gears fit on that hex

The outside 2 gears are for high and low gear. The middle gear is driven by a pair of cims.

Am I two for two?

Lil' Lavery · #11 23-01-2007, 23:11

Gearbox shafts
2 spur gears placed on the hex
Dog (or pin) placed in between

Travis Covington · #12 23-01-2007, 23:19

Quote:

Originally Posted by Holtzman

Gearbox Shafts

1st stage

3 Gears fit on that hex

The outside 2 gears are for high and low gear. The middle gear is driven by a pair of cims.

Am I two for two?

This guy's good! Not quite though... 2 gears fit on the hex. The bulge you see will be the third gear.

I'll post another picture in a few minutes. The next part should be MUCH easier though.

David Brinza · #13 23-01-2007, 23:38

Black plastic = acrylic?

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
pic: 968 - A few unfinished parts	Travis Covington	Extra Discussion	33	25-01-2007 23:02
More toys for 968	Kirk	Robot Showcase	2	13-02-2005 01:40
pic: 179's Control Box (unfinished)	CD47-Bot	Extra Discussion	14	11-03-2004 10:52
More Parts in Library	archiver	2001	0	23-06-2002 23:01
More Parts Needed	Jessica Boucher	Technical Discussion	0	02-12-2001 04:09