|
|
|
 Maybe the lesson the internet is trying to teach us is to "Think before you post, the machine is watching and never forgets..." - IKE [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Maybe the lesson the internet is trying to teach us is to "Think before you post, the machine is watching and never forgets..." - IKE [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
23-01-2007, 19:26
|
||||
|
||||
|
Re: Which pinions for FP motors and BaneBots 42 mm gearboxes?
3.2mm. I just ordered the same stuff today, and was curious to see what size...so I took out the calipers and measured the shafts of the FP motors. They are exactly 1/8", which is 3.175mm, which will fit the gears.
Make sure you get a gear puller if your dont have one already. Then you can re-use the ones on the 550's, or have some spare ones lying around (which wouldn't be a bad idea). |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Are all banebots motors allowed? | EnderWiggin | Motors | 7 | 11-01-2007 22:27 |
| Motors and gearboxes from the kit | Kam1310 | Motors | 21 | 10-03-2005 22:26 |
| Motors and gearboxes in the kit | Kam1310 | Technical Discussion | 1 | 09-03-2005 17:43 |
| Which team do u think used firsts gearboxes the best. | 18voltMilwauke | General Forum | 5 | 17-04-2003 12:01 |
| Pressure angles for motor pinions | Ian Mackenzie | Motors | 5 | 10-01-2002 15:05 |
Threaded Mode