|
|
|
 I wish I were on the GDC, just to watch everyone struggle to grasp the meaning of this. - Brandon_L [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I wish I were on the GDC, just to watch everyone struggle to grasp the meaning of this. - Brandon_L [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#22
24-01-2007, 22:50
|
|||
|
|||
|
Re: CMUCam, Easy C, and Labview
is the dongle the only way to get the code working? It looks like it could take some time to get that in, and I saw the alternative is to make one, which I will have our electronics team look at. I thoght I saw somewhere a mention about manually changing jumpers on the Interface unit to get the autonomous to work. Can it be done without the dongle?
thank-you |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Labview CMUcam demo problem | Windward | LabView and Data Acquisition | 19 | 11-08-2007 02:33 |
| Problems with CMUcam & LABView | Daniel_H | LabView and Data Acquisition | 1 | 30-01-2006 12:07 |
| Major CMUcam issues - LabView app won't work, very low-quality picture | scottmso | Programming | 5 | 19-01-2006 17:51 |
| National Instruments LabVIEW and Data Acquisition Forum | Danny Diaz | National Instruments LabVIEW and Data Acquisition | 1 | 16-01-2006 13:20 |
| COM port settings for CMUcam labview testing and programming | pwilczynski | Programming | 1 | 15-01-2006 15:09 |
Threaded Mode