|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
|
|||
|
|||
|
Re: pic: prototype of ramp in up postion
As I was looking at your model, I knoticed that at the position when the ramp is at its max, the piston is pulling dirrectly vertical. When it is in this position, the force from the piston is not able to prevent the ramp from going back down a little ways until the piston has a better pull angle. I think that you would have better luck if the piston was pulling at a slight angle when the ramp is fully up, or you figured out some other way to prevent this from happening.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: Fallbot prototype | amos229 | Extra Discussion | 5 | 05-09-2006 22:02 |
| pic: 1251 Prototype v 1.2 | David Guzman | Extra Discussion | 28 | 16-01-2006 12:14 |
| Got an question on start postion of the robot? | DanTheRobotMan | Rules/Strategy | 9 | 12-01-2006 17:32 |
| pic: 35 MPH Prototype | Crebb | Robot Showcase | 31 | 31-03-2005 16:02 |