|
|
|
 The minibot horse is dead. Stop trying to beat it. Glue is too cheap. - Taylor [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| The minibot horse is dead. Stop trying to beat it. Glue is too cheap. - Taylor [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
25-01-2007, 18:53
|
|||
|
|||
|
Re: pic: IFI Charger Parts Layout
Good point. If etching a board I would make the paths wider. We did not make a board from this, the intent was to use it as an aid for laying out the parts on a breadboard. It is easier to visualize, and the 317 terminals are not intuitive.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| pic: 931 Preliminary Electrical Layout | Richard Wallace | Extra Discussion | 15 | 30-01-2007 14:02 |
| pic: IFI-WHEEL v2.1 | InnovationFirst | Extra Discussion | 8 | 15-11-2006 09:39 |
| pic: Interacter X5 charger | Jimmy Holmes | Extra Discussion | 4 | 24-10-2006 18:09 |
| pic: IFI-WHEEL v2 | InnovationFirst | Extra Discussion | 15 | 28-08-2006 20:23 |
| pic: Dented IFI Wheel | Jeff K. | Extra Discussion | 11 | 08-03-2006 20:36 |
Threaded Mode