|
|
|
 All hail the amazing duct tape and the mighty zip-tie!!! :] - Gabe [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| All hail the amazing duct tape and the mighty zip-tie!!! :] - Gabe [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Our Camera doesn't Detect
Our 2007 Controller was broken so we are using 2006 micro-controller. I downloaded Kevin 2007 Camera code in 2006 controller. I attached Pan - pwm -01 and Tilt - 02. I connected the camera on a TTL and attached it with to a camera with using pwm cable. Than i connect a pwm cable to power camera on pwm pin 3. However, the camera doesn't turn on [No green light]. I take the pwm cable out of pin 3 and put it on analog 1 and the green light turns on
 Now the camera shows "Searching" on terminal window. However, the pan and tilt servo's don't move. Can someone please tell me what mistake we might be making. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| So what happend with our camera? | Rombus | Programming | 12 | 19-03-2006 00:34 |
| Camera Config doesn't save! | comwiz7 | Programming | 2 | 20-02-2006 17:19 |
| Camera doesn't have firmware? no programming? | GraphicArtDesig | Programming | 6 | 19-01-2006 20:10 |
| For anyone who doesn't get the camera code..... | Jake M | Programming | 8 | 16-01-2006 18:56 |
| Minor Problem, our robot DOESN'T work! | Cobra | Motors | 1 | 15-02-2003 14:43 |
Threaded Mode