|
|
|
 I might be singing a different tune if I get a water jet for Christmas. :) - FrankJ [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| I might be singing a different tune if I get a water jet for Christmas. :) - FrankJ [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#4
27-01-2007, 11:26
|
|||||
|
|||||
|
Re: Fork Connectors
Cody,
The design of the Victor and the power input to the RC can cause problems with fork connectors if they are not checked by your electrical pit crew on a regular basis. Often, over tightening the mounting screw will spread the forks and cause the distance between adjacent connectors to shrink. We use a push on adapter that is designed with a screw hole at one end and a push on at the other end. This way, damaged components can be replaced without tools and electrical check time is vastly reduced. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Controlling a "fork lift" type mechanism. | Brad Voracek | Programming | 4 | 18-01-2007 22:53 |
| the FSK show (fork, spoon and knife show) | Psalms(118:6) | Rumor Mill | 0 | 23-04-2004 08:33 |
| Slip connectors (custom electrical connectors) | Damian Manda | Electrical | 2 | 08-02-2003 17:53 |
| Fork Lift Robot | tinyfarnsworth | General Forum | 64 | 16-04-2002 12:09 |
| RJ-45 connectors, DB25 connectors and the like: legal or no? | Andrew Wyatt | Technical Discussion | 6 | 04-01-2002 22:53 |
Threaded Mode