|
|
|
 Probably planning on milling the bumpers out of solid pool noodle stock, too. Ever wonder how they drill that hole down the middle of pool noodles? ;) - Bill_B [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Probably planning on milling the bumpers out of solid pool noodle stock, too. Ever wonder how they drill that hole down the middle of pool noodles? ;) - Bill_B [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
28-01-2007, 22:06
|
|||
|
|||
|
Re: quation problem with Transmission vary bad fraction slepy
There is too much friction in the gearboxes or on the tires/wheels?
At this point, I'd see what you can do to remove the friction, or if they'l ship to you and you can afford it, buy a couple of these: http://andymark.biz/am-0011.html with regards to drill gearboxes, I think you have better options elsewhere. Also, keep in mind that only the motors in the kit + 2 small CIM + 1 large CIM are allowed. No other motors. Last edited by sanddrag : 29-01-2007 at 16:18. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| How "bad" are motors with "bad" stickers? | cooknl | Kit & Additional Hardware | 20 | 12-01-2005 10:33 |
| Problems with transmission using Inventor 8 | Drew Hopman | Inventor | 4 | 10-01-2005 19:07 |
| Anyone else with a really bad robot? | Lord Nerdlinger | General Forum | 49 | 08-04-2004 22:20 |
| Problem with communicating with STAMP through serial port | Skabana159 | Technical Discussion | 2 | 06-02-2003 21:10 |
| Mating gear with drill transmission | thedillybar | Technical Discussion | 0 | 13-02-2002 21:08 |
Threaded Mode