|
|
|
 You're here for them, not for you. - Chris is me [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| You're here for them, not for you. - Chris is me [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
29-01-2007, 13:39
|
||||
|
||||
|
Re: Banebot 56mm gearbox - double D related
May I add that this same problem is happening with the 42mm gearbox's, which many teams planed to use with the FP motor to power an arm. It will fail on you quicker than the 56mm drive gearbox's. If I was on or mentoring a team planing on using these gearbox's I would tell them to grab a pair of single speed Andymark gearbox's which for the same price accept 2 CIMs or 1 Bike CIM and 1 CIM.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode