|
|
|
 2004 qualifies as vintage now? Ugh. - Lil' Lavery [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| 2004 qualifies as vintage now? Ugh. - Lil' Lavery [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
29-01-2007, 15:45
|
||||
|
||||
|
Re: Banebot 56mm gearbox - double D related
Dr. Joe.
We are using 1 CIM w/ 12:1 ratio. An ME here would like to know how you calculated the stress. Below is his observation from the photos as well as conversations with me. "The initial interface is 2 lines of contact (essentially zero area) between the shaft and the D hole. It is only after material begins to deform (ever so slightly) that area contact is made. I am curious what he uses for stress area and how he determines it." C. B. Petrovic Last edited by cbpetrovic : 29-01-2007 at 15:48. Reason: Additional material |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode