|
|
|
 Mr.Lavery You Make My Day - Rohith Surampudi [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Mr.Lavery You Make My Day - Rohith Surampudi [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||
|
|||
|
Re: Attaching Mini-Bike motor to stock banebot gearboxes!
We were able to mate the big CIM to the BB 56mm tranny by doing the following.
- Machined the face of the Big CIM flat leaving a 1" OD X .13" tall boss in order to retain the bearing. I Also removed the "ear". - Drilled and tapped 4 10-32 holes on a 2" diam bolt hole pattern. - The output shaft was keyed with a tiny endmill, and trimmed slightly. The above make the face of the big CIM just like the regular one except that the boss is 1" vs 3/4" OD - Finally ID of the housing of the gearbox was opened from 3/4" to 1" diam in order to accomidate the larger boss. -Ted #1348 JFK HS, Denver, CO |
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebot 2 motor adapter | Ben Piecuch | Motors | 5 | 17-01-2007 16:06 |
| Mini-bike motor on the bane bots gear box | free_rider_151 | Technical Discussion | 2 | 12-01-2007 21:17 |
| New Model Posted - Mini Bike Motor | Ed Sparks | Inventor | 0 | 18-01-2006 23:03 |
| Poll: CIM vs. Bike Motor? | Swan217 | Motors | 18 | 14-01-2006 13:02 |
| Anyone modifying the stock gearboxes? | Swampdude | Technical Discussion | 17 | 04-02-2005 13:15 |
Hybrid Mode
