Programming Analog Input from 2004 Controller

Kevin Watson · #1 29-01-2007, 23:42

I just re-read you message and had a look at the 2005 ADC code. It looks like your problem is that build still uses the old non-buffered IFI serial port code. Try dropping in my serial port code and it should work just fine. If you run into problems send me your code and I'll have a look.

-Kevin

Danny Diaz · #2 30-01-2007, 00:11

Quote:

Originally Posted by Kevin Watson

Try dropping in my serial port code and it should work just fine. If you run into problems send me your code and I'll have a look.

We'll give that a try, thanks!

-Danny

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
FRC analog input RC filter values	Gdeaver	Control System	2	01-01-2006 22:03
Analog and digital input question	Robby	Control System	7	30-04-2005 20:07
Analog Input Trouble	Matt Krass	Programming	10	20-01-2005 21:09
Resistance to Analog Input Value.	Josh Hambright	Electrical	12	15-04-2003 16:12
DC Motor current to an Analog Input	junkyarddawg	Motors	43	04-04-2002 15:53