|
|
|
 Looks great! Love that Indiana engineering!! - Mr.D [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Looks great! Love that Indiana engineering!! - Mr.D [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#18
30-01-2007, 13:49
|
|||||
|
|||||
|
Re: Banebot 56mm gearbox - double D related
The output shaft is actually 1/2" (0.500") at the "outside" end, and 12mm (0.472") where it passes thru the bearings. So, you could not assemble the gearbox with your plan, unless you changed the whole bearing mounting design.
The obvious solution to the problem is to spline the shaft and plate, but then you get into interchangeability and manufacturing issues. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode