|
|
|
 Like a moth to a flame, true FIRSTers are attracted by the Victor instead of the Banner. - Rich Wong [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Like a moth to a flame, true FIRSTers are attracted by the Victor instead of the Banner. - Rich Wong [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
30-01-2007, 14:33
|
||||
|
||||
|
Re: Re-wiring 24V double solenoids
Good morning,
If you are simply trying to fix the solenoids you recently received from SMC it is very simple...no wiring required... On the side of each double solenoid and one side of the single you will find small grey coils which are marked 24 volts... Remove the two screws that hold them in and use the replacement coils provided by SMC in place of them... You even get extra screws if you lose one while taking them out.... that's all you need to do... replace the 24 volt coils with the 12 volt coils and bingo you have 12 volt solenoids... I hope this is what you were looking for... good luck!!! R |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| have a question to ask about Double Solenoids to one spike programming | davelu | Programming | 3 | 22-02-2005 09:52 |
| Purchasing double solenoids | bob1million | Pneumatics | 11 | 08-07-2004 03:17 |
| wiring solenoids | Brawler006 | Electrical | 10 | 22-02-2004 21:06 |
| Double Solenoids - assembly. | Frank(Aflak) | Pneumatics | 9 | 06-02-2003 20:33 |
| Rookie Question. double solenoids... | archiver | 2001 | 2 | 24-06-2002 00:57 |
Threaded Mode