|
|
|
 That's not duct tape as adhesive, it's duct tape as decoration! :p - Don Knight [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| That's not duct tape as adhesive, it's duct tape as decoration! :p - Don Knight [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#19
30-01-2007, 18:10
|
||||
|
||||
|
Re: Banebot 56mm gearbox - double D related
My team requested that I post the following information.
The attached images show the problem we have encountered with the transmissions. We first did a 30 minute run in of the motors and transmission with no load. Two days later, we did about 10 minutes of test driving. Full forward, full reverse, rotating, basically each combination of joystick maneuvers possible. Hopefully this data will help teams that want to keep using these transmissions find a fix. We on the other hand, have decided to switch to the AM Single Speeds. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode