|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#32
|
|||
|
|||
|
Re: Banebot 56mm gearbox - double D related
So after reading all the posted information and an experiencing an appropriate amount of panic, we are ditching the 56 mm planetary gearboxes for a pair of Andy Marks.
It does not make much sense to us to have worked hard over the last year to build a better organization, recruit more team members, mentors, and sponsors and hope a fundamental piece in the KOP will hold up. Imagine the frustration, tears and anger that would follow if the transmissions fail. Oh and the Rule 7 updated posted today did not make us all warm and fuzzy either!! Switching was a no brainer. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |