|
|
|
 To all programmers: you are Geniuses! - Ashley Weed [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| To all programmers: you are Geniuses! - Ashley Weed [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#34
30-01-2007, 21:44
|
|||
|
|||
|
Re: Banebot 56mm gearbox - double D related
I saw this mentioned on another threat in a previous post, has anyone tried welding the two (gear and plate) together? Are there any significant downsides to attempting this, as it seems like a relatively simple (if welding is available) fix...
Also, has anyone tried pinning the two? That idea was tossed around this evening, milling and pinning at three or four points the gear to the plate. This would support the central pivot on the double D, if nothing else. Just some thoughts, drawing and (hopefully good) results forthcomming |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode