|
|
|
 They can either incorporate the suggestions in this thread, go totally against them, or even make us all write code on banana peels with our fingernails. - Andy Baker [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| They can either incorporate the suggestions in this thread, go totally against them, or even make us all write code on banana peels with our fingernails. - Andy Baker [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#12
30-01-2007, 23:28
|
|||
|
|||
|
Re: Evaluation Board Gyro
It should work if you just wire the twist pins, but go ahead and do the temp pins two. Perhaps the board wants power at both. You don't have to do anything (program wise) with the data. Then make sure your program is accessing the correct analog port for the twist signal.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lights in Joystick board or control board | rcubes85 | Control System | 15 | 26-02-2005 23:40 |
| Gyro | magical hands | Programming | 2 | 14-01-2005 20:57 |
| Perf Board = BS2-IC Carrier Board? | indieFan | Electrical | 2 | 16-09-2004 08:28 |
| Gyro | archiver | 2001 | 2 | 23-06-2002 23:11 |
Threaded Mode