|
|
|
 If you don't like contact, your robot is not built well enough. - sanddrag [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you don't like contact, your robot is not built well enough. - sanddrag [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#26
31-01-2007, 00:00
|
|||
|
|||
|
Re: Banebot 56mm gearbox - double D related
I have access to an EDM (actually, three), and I could look into making a whole bunch of these plates out of something super hard (haha... im not a metals expert here
 ) If someone had a CAD drawing, that would be great...Just last night we had to burn threads into some stuff... the scrap we found was hard  ~Dave |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode