Question on mounting components

[Mike Hendricks]

Originally Posted by Kevin Sevcik

mounting on both side of the board is fine, provided you follow all the rules. Specifically, the indicator lights on the RC must be visible standing 3 feet in front of the robot in its starting configuration, and the breaker must be accessible for inspection.

Care to reference the rule that says that? It's advisable that the RC lights are visible, so field staff / IFI reps can easily see and confirm your RC is ready to go. Unless I'm blind (or if it managed to slip through a team update .. ), I have yet to see a rule that says that the lights on the RC have to be visible from 3 feet away, standing in front of the robot.

The AB indicator light on the other hand, needs to be visible (not sure on the spec, but I know it is required on the bots this year. Perhaps you're getting the RC and the new indicator confused?

[Joe Ross]

Originally Posted by PhatMike

Care to reference the rule that says that? It's advisable that the RC lights are visible, so field staff / IFI reps can easily see and confirm your RC is ready to go. Unless I'm blind (or if it managed to slip through a team update .. ), I have yet to see a rule that says that the lights on the RC have to be visible from 3 feet away, standing in front of the robot.

<R68>

Originally Posted by R68

The Robot Controller must be positioned within the ROBOT so that its indicator lights can be
seen during inspection and when standing three feet in front of the ROBOT while the
ROBOT is in the STARTING CONFIGURATION at the beginning of a match. This will
greatly facilitate analysis in case of problems.

[Richard Wallace]

Per the recently issued inspection checklist, both the <R16> requirement for signal light visibility and the <R68> requirement for RC indicator light visibility will be checked at inspection. Refer to checklist items 11 and 24.