|
|
|
 Cash is always better, remember that when fund raising. - LordDumpling [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Cash is always better, remember that when fund raising. - LordDumpling [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#8
31-01-2007, 07:14
|
||||
|
||||
|
Re: Banebot 56mm gearbox - double D related
Dr. Joe...
When we reported the gross failure of one of the drive systems, we failed to mention that we pulled the other three gearboxes off and observed the same damage, although to a lesser degree. Ron Reich, a new ME mentor on the team, had done the research and determined that the 4140 prehardened steel would provide double the resistance to stress that the original carrier plates can withstand. We will be having new plates made and as soon as we get them, we'll report back on how well that works. C. B. Petrovic - Team 166 |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| opening up the BaneBot gearbox to install the CIM motor | jskene | Motors | 9 | 22-01-2007 11:12 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |
Threaded Mode