|
|
|
 Most of our old robots have been scrapped for parts. Our Chairman submissions are still read every year by the whole team. - N7UJJ [more] |
 |
|
|||||||
|
||||||||
 |
| Thread Tools | Rate Thread | Display Modes |
|
|
|
| Most of our old robots have been scrapped for parts. Our Chairman submissions are still read every year by the whole team. - N7UJJ [more] |
|
|
|||||||
|
||||||||
|
| Thread Tools | Rate Thread | Display Modes |
|
#1
|
|||
|
|||
Trouble with the treads in the brass fittings?
Anyone else having troubles with the brass fittings being too tight for the cyliners?
 
|
|
#2
28-01-2007, 15:17
|
|||||
|
|||||
|
Re: Trouble with the treads in the brass fittings?
They should be tight so that air pressure does not escape. They also might be tight if you use too little or too much Teflon tape.
|
|
#3
31-01-2007, 07:57
|
||||
|
||||
|
Re: Trouble with the treads in the brass fittings?
The threads are tapered. They will not screw all the way down to the cylinder.
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trouble in the land of the B.E.A.S.T. or.. What's your school policy on dress? | Elgin Clock | Chit-Chat | 26 | 28-02-2007 19:09 |
| Trouble with Programming the EDU Bot | TotalDomination | Programming | 14 | 11-10-2005 10:58 |
| Success with Tank Treads | Yan Wang | Technical Discussion | 17 | 23-01-2004 15:53 |
| Im am having trouble with the MPLAB | hedgehogger | Programming | 7 | 19-01-2004 17:37 |
| Anyone else having trouble with the pneumatics manual? | Stu Bloom | Pneumatics | 15 | 13-01-2004 01:13 |
Linear Mode
