|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
|
|||
|
|||
|
Re: Mecanum problems
The issue is not in the programming or at least we don't think its is.
We saw, referenced, and used that link previously. We think the issue is mechanical. BTW those with the AndyMark Mecanum's did you put the wheels together so that the writing was on the inside or so that the two plates that you were using would be parallel. By parallel i mean the fit together flat. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| mecanum programming | mrmummert | Programming | 27 | 28-01-2007 13:45 |
| Mecanum | Rob2713g | Technical Discussion | 13 | 03-11-2006 14:16 |
| Labview problems and code problems | ajsetter | Programming | 25 | 18-01-2006 17:07 |
| Mecanum Wheels | TheFerret | Technical Discussion | 8 | 16-01-2006 09:23 |
| mecanum patents | piotr_boch | Technical Discussion | 6 | 25-11-2005 20:03 |