|
|
|
![]() |
|
|||||||
|
||||||||
![]() |
| Thread Tools | Rate Thread | Display Modes |
|
#16
|
|||||
|
|||||
|
Re: Microswitch problem
Here is a table of how to set the relay values to get the different results possible. It's from the IFI Spike document: http://www.ifirobotics.com/docs/spik...uide-sep05.pdf
We don't usually set both "rev" and "fwd" to 1 at the same time. Both fwd=0;rev=0; as well as fwd=1;rev=1; should mean the motor is off. This code will execute one section only as long as the switch is depressed and the other whenever the switch is not pressed. |
![]() |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| G.T.S ..... (problem) | Ami Schwartz | Programming | 3 | 28-01-2006 17:01 |
| A linking problem | T Shap | Programming | 6 | 15-01-2006 00:23 |
| Problem | Hailfire | CD Forum Support | 7 | 06-10-2002 15:02 |
| PROBLEM!!!!!!?????? | Clark Gilbert | CD Forum Support | 9 | 02-12-2001 12:43 |