Banebot 56mm gearbox - double D - RELOADED

[Joe Johnson]

Originally Posted by Daniel_LaFleur

Joe,

The material stated on your drawing. Is that the material we should make it out of, or the material it was made out of?

There are many mat'ls that will work. I recommend that you talk to your source and pick one that has a RC23 hardness out of the shoot (i.e. without heat treating). The mat'l on the print is what I would do if I wanted to end up with a RC40 or so part. But you can relatively easily machine RC23 parts (or I should say, some machine shops can). Talk to the source about what they can get easily. If the mat'l is RC23 or higher, it should be fine.

Joe J.