again, problems with the camera

bear24rw · #1 01-02-2007, 18:30

Are you using the default camera code that kevin wrote?
www.kevin.org/frc

razer · #2 02-02-2007, 06:51

Quote:

Originally Posted by bear24rw

Are you using the default camera code that kevin wrote?
www.kevin.org/frc

yes, i use his default code.

Bomberofdoom · #3 02-02-2007, 09:26

You mean, it finds the light, but doesn't follow. It finds it, stays in it's position and only once the light is out of range it starts moving for searching mode untill it finds the light again? Kind of sounds like what happened to us before the TTL problem, but we might still have it. Will check next week.

razer · #4 02-02-2007, 11:50

i think i found the problem,
i saw that the PWM of the power slides out a bit while the camera is rotating because the camera is ratting a bit while searching the green light, and i try to shake this PWM by myself and i saw that the LEDs were turning off for half a second and then turns on again, so i just tightened the wires...
thanks anyway for trying to help me

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
problems using gyro/adc code with camera default code	tanstaafl	Programming	7	22-01-2006 23:09
problems with my truck again.	greencactus3	Chit-Chat	12	30-11-2005 17:49
yet again i have more computer problems	Timmyd	Chit-Chat	22	27-11-2005 16:30
problems mounting the camera to the 'bot with the default servo/mount set up	Redneck	Programming	0	16-02-2005 20:53
Once again offering problems, but no solutions	archiver	2000	1	23-06-2002 22:53