|
|
|
 It is better to err on the side of caution than to put yourself in a position to have a referee or judge make a call against you. Build smart! - Sean Schuff [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It is better to err on the side of caution than to put yourself in a position to have a referee or judge make a call against you. Build smart! - Sean Schuff [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
||||
|
||||
|
Re: Anyone else have this?
As far as I know, yes. I didn't inspect the holes on our gearbox. However, we just installed our encoder today, and I noticed there was a slight difference in the spacing of the holes on the two different parts of the encoder assembly. Since it all fit together very nicely, I can only assume that the holes on the gearbox must also have been spaced differently.
|
|
#2
02-02-2007, 09:26
|
||||
|
||||
|
Re: Anyone else have this?
except on the inventor file from firstcadlibrary they are spaced evenly. I think it's pointless making them differ in spacing so little yet enough to limit what you can do with it...I'm sure the encoder has enough space for equadrilled holes
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Anyone else have any piercings or tattoos? | Josh Hambright | Chit-Chat | 25 | 11-01-2008 23:54 |
| did anyone else have this problem? | NuclearPeanut | FIRST Tech Challenge | 0 | 25-04-2005 14:34 |
| Anyone else have school cancelled? | ryanspensley | Chit-Chat | 14 | 09-04-2003 06:03 |
| Anyone else have trouble flying? | authgeek1218 | Championship Event | 7 | 07-04-2003 02:35 |
| 118's Valkyrie Rides... (anyone else have videos?) | Kris Verdeyen | Robot Showcase | 0 | 24-02-2002 21:13 |
Hybrid Mode
