|
|
|
 Our Digital Sidecar can attract metal chips from distant planets. - electroken [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Our Digital Sidecar can attract metal chips from distant planets. - electroken [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#3
02-02-2007, 15:43
|
|||
|
|||
|
Re: Camera code completely turning off all PWM's
I've scanned through the code, it's the most recent on Kevin's website, and I haven't found any large sections of code commented out. Is anyone else experiencing this? I'm pretty sure that I haven't augmented anything that would completely disable the PWM outputs.
**Edit** Also, I did add in one line of code to power the camera. I'm pretty sure that this should be no problem. It's in the User_Initialization() under User_Routines.c, right after all of the pwm's and digital i/o's are set: digital_io_17 = 1; The camera is getting the green light and receiving data, but the servo's are not. Is it ok to set this variable to power the camera? Last edited by Horohoroboarder : 02-02-2007 at 15:54. |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Camera for turning | DustinB_3 | Programming | 18 | 17-02-2007 21:00 |
| Does the camera code suits to all versions of MPLAB and C18? | razer | Programming | 3 | 04-01-2007 14:50 |
| Turning motors on and off in the KitGearbox? | Andrew Blair | Kit & Additional Hardware | 4 | 31-12-2005 10:33 |
| Slowing down Camera drive turning | Zalumaskov | Programming | 1 | 27-02-2005 10:11 |
| Victor turning off | zeep25 | Electrical | 10 | 23-02-2004 18:35 |
Threaded Mode