PWM Problem with Default Code

kbregler · #8 03-02-2007, 07:07

I didnt answer all the questions, sorry, it was 2AM.

Since the unit operates perfectly fine with code that shipped on the controller I dont think any of the items are bad. We have 4 joysticks we used with no luck, the Motor controllers operate as needed with the code that shipped on it so they are connected correctly and calibrated.

Even the PWM LEDs are mapped wrong so it shows that its something internal, and they are correct with the code that shipped on the controller.

I have even tried downloading the default.hex file they give you with the default code and it does the same thing.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Problems with Kevin's 2007 default code	bruss6	Programming	8	19-01-2007 15:42
problems using gyro/adc code with camera default code	tanstaafl	Programming	7	22-01-2006 23:09
Default code problem	capenga	Programming	8	01-02-2005 08:09
problem with the default code	MarkVH	Programming	7	28-01-2005 00:04
Problem with FRC Default code	AsimC	Programming	2	11-01-2004 19:22