Problem with Inventor 11 Dynamic Sim Tutorial?

Elpants · #1 04-02-2007, 00:44

Quote:

Originally Posted by worldbringer

Are you using the Help tutorial or the tutorial in the Getting Started manual?

The one that asks if I want to run it whenever you open up the dynamic sim.

Dan Zollman · #2 04-02-2007, 01:11

Quote:

Originally Posted by Elpants

The one that asks if I want to run it whenever you open up the dynamic sim.

I don't remember having any problems with that one, but I'll look at it again tomorrow.

Dan Zollman · #3 04-02-2007, 21:29

That didn't happen to me when I followed the first few parts of the tutorial. I don't know why it would happen...but make sure that you're using the original gate.iam file that came with Inventor and not a modified version of it.

Thread Tools
Show Printable Version Email this Page
Display Modes	Rate This Thread
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode	Rate This Thread:

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Urgent problem, probably with Inventor 11 install.	Eric Scheuing	Inventor	4	03-01-2007 07:43
Inventor Problem w/ saving	Pat Roche	Inventor	2	14-02-2005 21:36
Dynamic Linking with PHP	plutonium83	Website Design/Showcase	6	12-01-2005 19:41
HELP! Problem with General Dimension in Inventor 5.	sanddrag	Inventor	12	21-09-2003 21:46
Problem with communicating with STAMP through serial port	Skabana159	Technical Discussion	2	06-02-2003 21:10