|
|
|
 P.S. While I doubt Karthik's "Delgado" jersey would go for $500,000... it would be much cooler to see Carlos Degado wearing a "Kanagasabapathy" jersey. THAT I might pay for! - dtengineering [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#1
|
||||
|
||||
|
Quick Vacuum Release
Hello
I am very new to the concepts of pneumatics and this is our first year using them. We have gone with a vacuum design and are looking for a way to quickly release the negative pressure caused by the vacuum. What do we need to use in order to release the pressure? Is there a device that piab sells to connect to the end? (I have looked and don't know enough to know what I need to look for) Thanks for the help and I hope everyone is getting close, or done, with building and testing their robots. I hope some of you might be able to make it down to Vegas to spend some time with us. Thanks! |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quick release wire harness | mechanicalbrain | Electrical | 2 | 08-01-2006 15:36 |
| Vacuum | NoRemorse | Rules/Strategy | 25 | 22-01-2004 12:34 |
| openFIRST Release -- 'Twas the Release Before Christmas | Timothy D. Ginn | FIRST-related Organizations | 3 | 25-12-2003 23:44 |
| Vacuum | nwagers | Pneumatics | 16 | 31-10-2003 15:57 |
| Quick release battery connector and 120 amps | n[ate]vw | Electrical | 6 | 18-01-2003 23:41 |
Threaded Mode