|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#2
|
|||||
|
|||||
|
Re: RS-545HS Gear and Pressure
I know that it has a 3.2mm shaft, and you can remove the gear with a special gear puller that you can buy for under $20 from Banebots and probably from lots of Radio Control car hobby stores. Then you can intall the gear you need on the motor. The gear should be available from the place that sells the transmission you are planning on using, or from the motor that came installed on that transmission.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| KitBox Gear Info - What pressure angle? | coreyjon | Technical Discussion | 2 | 14-02-2005 22:01 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| Dump valve and pressure gage's | tareyton | Pneumatics | 3 | 06-02-2003 21:13 |
| Gear Pressure Angle and Pitch. | Patrick Wang | Technical Discussion | 20 | 13-08-2002 20:33 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |