|
|
|
 Team 233 cannot wait for the Florida Regional, but they have to because they have to build a robot or something first. . . - IbleedPink233 [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| Team 233 cannot wait for the Florida Regional, but they have to because they have to build a robot or something first. . . - IbleedPink233 [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#9
04-02-2007, 22:05
|
||||
|
||||
|
Re: Code to have speed of motors dependent on how hard you push the joystick
Good. Doesn't hurt to check for simple problems.
 Do the motors immediately start turning when the robot is reset? Have you tried moving the centering dials beside the stick to center the joystick? Are the PWM1 LEDS lit when the joystick is centered? There is no change when you move either joystick? The motors don't reverse at all? Both joysticks do the same thing? Can you copy the lines of code where you read one joystick value and then assign it to the PWM output and post it here (or send it in a private message)? |
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Code to increase speed when joystick is pushed further | JoJo5 | Programming | 3 | 06-02-2007 07:29 |
| How Many Motors Have You Dropped This Year? | littleelectron | Motors | 5 | 05-02-2004 16:03 |
| How do you connect the speed controller fans? | Iain | Electrical | 7 | 31-01-2003 07:05 |
| How do you set a speed limit on the servo | Fares | Programming | 6 | 01-01-2003 15:04 |
| How fast are you planning to push/pull a goal? | Anton Abaya | Rules/Strategy | 7 | 12-01-2002 23:33 |
Threaded Mode