|
|
|
 It's not GP, its not un-GP, its just a strategy. - AndyB [more] |
 |
|
|||||||
|
||||||||
 |
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| It's not GP, its not un-GP, its just a strategy. - AndyB [more] |
|
|
|||||||
|
||||||||
|
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
#1
|
|||||
|
|||||
|
Re: RS-545HS Gear and Pressure
I think my post above was not very clear, because you seem to not have deduced what I meant....sorry for that!
I meant to take the mystery gear off the 545 mabuchi motor, and throw the gear away in the garbage. Then find a new gear that will fit the 3.2mm shaft, one that you know what the pressure angle and pitch are, and put it on the motor. 
|
|
#2
05-02-2007, 16:49
|
||||
|
||||
|
Re: RS-545HS Gear and Pressure
Thanks
|
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| KitBox Gear Info - What pressure angle? | coreyjon | Technical Discussion | 2 | 14-02-2005 22:01 |
| Translating pressure sensor readout into actual pressure | Mercutio | Pneumatics | 0 | 13-02-2004 16:29 |
| Dump valve and pressure gage's | tareyton | Pneumatics | 3 | 06-02-2003 21:13 |
| Gear Pressure Angle and Pitch. | Patrick Wang | Technical Discussion | 20 | 13-08-2002 20:33 |
| Error found in programming for the pump and pressure switch | sjharobotics | Programming | 4 | 06-02-2002 17:46 |
Hybrid Mode
