|
|
|
![]() |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#41
|
|||||
|
|||||
|
Re: Banebot 56mm gearbox - double D - RELOADED
Perhaps you didn't see one of the earlier threads on this subject, where welding the two pieces together was discussed, or where making the shaft one piece was discussed. The shaft is 12mm at the DD joint and the bearings, and 1/2" (12.7mm) at the other end. So, you need to braze it with the shaft installed in the bearings and the end mounting block. I would hesitate to do that....the heat would probably be hard on the bearings! plus you can't disassemble it without reheating and melting the braze.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Banebot 56mm gearbox - double D related | Joe Johnson | Motors | 78 | 31-01-2007 23:55 |
| small banebot motor with 64:1 gearbox | burkey_turkey | Motors | 16 | 29-01-2007 01:48 |
| Banebot Gearbox | chris31 | Technical Discussion | 45 | 15-01-2007 17:56 |
| Attempting to Cut BaneBot 56mm Shaft | edthegeek | Motors | 6 | 15-01-2007 08:51 |
| 56mm BaneBot Gearbox 15tooth sprockets. Where to buy more? | VEN | Technical Discussion | 4 | 11-01-2007 14:45 |