|
|
|
 If you're the smartest person in the room, you're in the wrong room! - Ian Curtis [more] |
 |
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
|
|
| If you're the smartest person in the room, you're in the wrong room! - Ian Curtis [more] |
|
|
|||||||
|
||||||||
|
|
Thread Tools | Rate Thread | Display Modes |
|
#6
07-02-2007, 08:57
|
||||
|
||||
|
Re: Vex encoders/Interrupts
Switching to an FRC controller shouldn't affect anything unless you change the code because the FRC controller and the VEX controller have the exact same microchips and are just packaged differently. Also, I was wondering how you are powering the Victors and motors because you don't appear to have a 12v FRC battery on the robot and running them off a 7.2v VEX battery could be causing your uneven drive problems if they are made to run off 12v.
|
| Thread Tools | |
| Display Modes | Rate This Thread |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Interrupts | JSonntag | Programming | 1 | 14-01-2006 12:43 |
| Vex navigation with ultrasonic and encoders | GlennGraham | Electrical | 4 | 13-01-2006 12:58 |
| VEX Optical Shaft encoders in FRC | sanddrag | FIRST Tech Challenge | 8 | 04-10-2005 07:52 |
| Encoders, interrupts, and edge-triggering issues | Alan Anderson | Programming | 6 | 11-03-2005 16:06 |
| Interrupts | CyberWolf_22 | Control System | 3 | 12-01-2004 21:46 |
Threaded Mode